To configure static routes on a VPRN site

Steps
 

Choose Manage→Service→Services from the NFM-P main menu. The Manage Services form opens.


Choose a VPRN service and click Properties. The VPRN Service (Edit) form opens.


On the service navigation tree, expand the Sites icon, right-click on a routing instance and choose Properties. The VPRN Site (Edit) form opens.


Click on the Routing tab, then on the Static Routes tab.


Define a static route that the PE VRF is to exchange with the CE:

  1. Click Create. The Static Route (Create) form opens.

  2. Configure the required general parameters.

  3. Configure the parameters in the Destination panel.

    The IP Address parameter is configurable when the Type parameter is set to an option other than Black Hole.

  4. Select an interface for the static route in the Destination panel.

  5. Select an IPsec tunnel for the static route in the Destination panel.

  6. Configure the parameters in the Other panel.

  7. Configure the parameters in the CPE Check panel.

    The Target IP Address, Interval (seconds), Drop Count, Log, and Packet Size parameters are configurable only when the Enable CPE Check parameter is enabled.

  8. Select a prefix list name in the Prefix List panel and configure the Prefix List Flag parameter. The Prefix List Flag parameter is configurable only when you choose a prefix list.

    Note:

    You cannot specify a Prefix List if BFD Enabled or Enable CPE Check parameters are enabled for the static route.

  9. Configure the parameters in the Source/Destination Class Index panel.

  10. Save the changes and close the form.


Save the changes and close the forms.

End of steps