To modify a VPRN service

CAUTION 

CAUTION

Service Disruption

Modifying parameters can be service-affecting.

The behavior of the VPRN service may become unpredictable if modifications to the configuration affect the IPsec portion of the service configuration. For example, if a VPRN service is configured with IPsec tunnels, IPsec SAPS, and policies are deleted, the service is not deleted from the NFM-P and the service will be in an inconsistent state. The IPSEC portion of the VPRN configuration must be deleted using CLI scripts or the CLI before the VPRN service can be deleted from the NFM-P.

Steps
 
1 

Choose Manage→Service→Services from the NFM-P main menu. The Manage Services form opens.

2 

Choose a VPRN service and click Properties. The VPRN Service (Edit) form opens.

The following tabs list the service elements that can be individually or collectively selected and configured:

  • Tests tab — allows the creation and execution of service-specific diagnostic tests

  • Sites tab — lists the sites that are included in the service

  • L3 Access Interfaces tab — lists the L3 access interfaces that are included in the service

  • Spoke SDP Bindings tab — displays the spoke SDP bindings that are associated with the service

  • Addresses tab — lists the IP addresses that are associated with the service

    Note:

    You cannot remove an IP address from an interface when the IP address of a static host is defined in the subnet of the interface IP address and the ARP Populate parameter is enabled on the Anti-Spoofing tab.

  • Faults tab — displays the faults associated with the service

3 

Modify the parameters for the service, as required.

To configure items in the tabs that contain lists of service elements, select the items and click Properties.

4 

Save the changes and close the forms.

End of steps