To bind a VPRN L3 access interface to a VPLS site or VPLS I-site

Steps
 

Choose Manage→Service→Services from the NFM-P main menu. The Manage Services form opens.


Choose a VPRN service and click Properties. The VPRN Service (Edit) form opens.


On the service navigation tree, expand Site→L3 Access Interfaces, right-click on an L3 access interface choose Properties. The VPRN L3 Access Interface (Edit) form opens.


Click on the Routed VPLS tab.

Note: The operational state of the IP interface binding will not be turned up until the Enable IP Interface Binding parameter is set to true.

You can create and manage a routed VPLS connector from the navigation tree on the Composite Service (Edit) form.


Enter a VPLS site name or select a VPLS site.


Configure EVPN Tunnel parameters as needed.


Expand the Ingress or Egress panel as needed.


To configure the filter policies:

  1. Select an IPv4 filter in the IPv4 Filter panel.

  2. Select an IPv6 filter in the IPv6 Filter panel.


To enable table-based color-aware ingress classification, select the Enable Table Classification For VPLS parameter, then select a 7210/7250 DSCP classification policy as the Routed Override QoS policy. See Table-based ingress classification on the 7210 SAS.


10 

To configure the egress QoS policies by selecting an QoS policy in the Egress QoS Policy panel.


11 

Save the changes and close the forms.

End of steps