To configure neighbor discovery on a VPRN L3 access interface

Steps
 

Choose Manage→Service→Services from the NFM-P main menu. The Manage Services form opens.


Choose a VPRN service and click Properties. The VPRN Service (Edit) form opens.


On the service navigation tree, expand Site→L3 Access Interfaces, right-click on an L3 access interface choose Properties. The VPRN L3 Access Interface (Edit) form opens.


Set the IPv6 Allowed parameter to enabled.


Click on the Neighbor Discovery tab and click Create. The Neighbor Discovery (Create) form opens.


Configure the required parameters.

For the neighbor address to be communicated to the NE, you must configure an SNMP community on the site. See To configure an SNMP community on a VPRN site .


Save the changes and close the form.


Click on the Proxy ND tab and configure the required parameters.

Note: Do not leave an empty policy parameter between two configured policy parameters. For example, do not configure the Policy 1 and Policy 3 parameters and leave the Policy 2 parameter unconfigured, or the NFM-P reorders the policies and moves the policy specified for the Policy 3 parameter to the Policy 2 parameter.


Click on the Secure ND tab and configure the required parameters.


10 

Save the changes and close the forms.

End of steps