|
|
1 |
Configure an OPS OSM-DSV card on an 1830 VWM OPS shelf:
-
On the equipment tree, expand Network→NE→Shelf→Card Slot n.
-
Assign the OPS OSM-DSV card, see
To assign a card type.
-
On the Card Slot (Edit) form, click on the Card Specifics tab and configure the Assigned Status parameter as Assigned.
-
Click Apply and confirm your actions.
-
Configure the required parameters in the OPS OSM-DSV Specifics panel.
-
Save your changes and close the form.
|
2 |
Configure bi-directional protection switching for the PSE-R:
-
On the equipment tree, right-click on the 1830 VWM-OSU NE and choose Properties. The NE (Edit) form opens.
-
Click on the PSE-R PMU-D group tab and click Create. The PSE-R PMU-D group (Create) form opens.
-
Configure the PMUD Group parameter.
-
Select one to four PMUD in the PMUD panels.
-
Click on the OPS PSE-R tab and click Create. The OPS PSE-R (Create) form opens.
-
Configure the required parameters.
Note: You must select a PMUD Group.
-
Click Apply. The OPS OSM PSE-R (Edit) form appears with the OPS OSM PSE-R protection switch management tab.
-
Configure the Activate parameter as True and configure the required parameters, if applicable.
-
Click Apply and confirm you actions.
|
3 |
Configure bi-directional protection switching for the PSE-L:
-
Click on the OPS PSE-L tab and click Create. The OPS PSE-L (Create) form opens.
-
Configure the Description parameter.
-
Select an OPS OSM-DSV card for the Slot parameter.
-
In the Worker Loop Monitor Interface panel, configure the port as OSC1.
-
In the Protection Loop Monitor Interface, configure the port as OSC2.
-
Click Apply. The OPS OSM PSE-L (Edit) form appears with the OPS OSM PSE-L protection switch management tab.
-
Configure the Activate parameter as True and configure the required parameters, if applicable.
-
Click Apply and confirm your actions.
|
4 |
Save your changes and close the forms.
End of steps |