To configure tunable optics for Ethernet satellites

Before you begin

You must create a 64-port 10-Gig SFPP Ethernet Satellite with 4 100-Gig QSFP28 up-links or 64-port 10-Gig SFPP Ethernet Satellite with 4 100-Gig CFP up-links on the 7750 SR, 7450 ESS, and 7950 XRS, Release 16.0 R4 and later.

The tabs and parameters that display vary depending on the type of Ethernet Satellite, and the NE and release.

Steps
 

On the equipment tree, right-click on the esat port of the Ethernet satellite and choose Properties.


Perform one of the following:

  1. Click Select beside the DWDM Channel parameter and choose the available channel. The other DWDM parameters are populated.

  2. Click the DWDM Optics tab and configure the required parameters.

    You cannot configure the center frequency if the DWDM channel parameter is configured.


Save your changes and close the form.

End of steps