To configure a Dynamic or segment routing TE LSP

Steps
 
1 

Choose Manage→MPLS→(Dynamic|Segment Routing) LSPs from the NFM-P main menu. The Manage (Dynamic|Segment Routing) LSPs form opens.

2 

Click Search. A list of the selected type of LSPs is displayed.

3 

Choose an LSP and click Properties. The (Dynamic|Segment Routing) LSP (Edit) form opens.

4 

Configure the Description parameter.

5 

Configure the Administrative parameter in the States panel.

6 

Click on the Accounting tab and select an accounting policy.

7 

Configure the parameters on the Properties tab.

8 

Click on the OAM tab to view or configure OAM tests.

9 

Click on the Statistics tab to view or configure statistics collection.

10 

Click on the Tunnels tab. A list of LSP path bindings is displayed. Perform one of the following:

  1. Create an LSP path binding.

    Use the following steps:

    1. Click Create. The LSP-Path Binding step form opens and the Choose Path Type step is displayed. The Type parameter is set to secondary if a primary path exists.

    2. Click Next. The Choose MPLS Path step is displayed. Choose an MPLS path to associate with the LSP. You can also create an MPLS path by clicking Create MPLS Path. See To create an MPLS path for more information.

    3. Click Next. The Set Traffic Options step is displayed. Configure the required parameters.

    4. Click Next. The Set Initial States step is displayed. Configure the Administrative State parameter.

    5. Click Finish to save your changes and close the form.

  2. Configure an existing LSP path binding.

    Use the following steps:

    1. Choose an LSP path binding and click Properties. The LSP-Path Binding (Edit) form opens.

    2. Configure the required parameters.

    3. Select a BFD template in the BFD panel and configure the required parameters.

      The BFD template can be assigned to either the LSP-path or the LSP, but not both.

      When the LSP path is up and operational, the BFD on LSP Sessions tab contains an entry for the head and tail, respectively. When a BFD session is removed or the path is deleted, the BFD sessions are removed. The BFD session shows information about the current BFD session. BFD session information is automatically updated when a change occurs on the NE.

    4. Configure the required parameters on the Administrative Groups tab.

11 

Click on the PCE-Associations tab. A list of LSP PCE associations is displayed. Perform one of the following:

  1. Create an LSP PCE Association.

    Use the following steps:

    1. Click Create. The MPLS LSP PCE-Association form is displayed.

    2. Select the Association type (Diversity or Policy).

    3. Select the pre-configured Associations from the list.

    4. Save your changes and close the form.

  2. Configure an existing LSP PCE Association.

    Use the following steps:

    1. Choose an LSP PCE Association and click Properties. The MPLS LSP PCE-Association (Edit) form opens.

    2. Configure the required parameters.

    3. Save your changes and close the form.

12 

Save your changes and close the form.

End of steps