To configure a shared policer policy

Purpose

A shared policer policy is a VLAN group policer for rate limit traffic from many VLANs. FCs from many VLANs are policed by the shared policer. The policy allows ingress policing to support a group of VLANs instead of a single VLAN.

Steps
 

Choose→Policies→QoS→SROS QoS→Shared Policer from the NFM-P main menu. The Shared Policer (Create|Edit) form opens.


Click Create or choose a policy and click Properties. The Shared Policer (Create|Edit) form opens.


Configure the required parameters.


Configure the CIR/PIR parameters:

  1. Click on the CIR/PIR tab.

  2. Configure the required parameters.


Configure the Burst Size parameters:

  1. Click on the Burst Size tab.

  2. Configure the required parameters.

    The parameters are configurable when the Default check box above each is deselected.


Click OK to save the policy and close the form, or click Apply to save the policy. See To release and distribute a policy to release and distribute the policy to NEs.

End of steps