To configure a service chaining VAS filter policy

Steps
 

Choose Policies→Residential Subscriber from the NFM-P main menu. The Residential Subscriber Policies form opens.


Click Create→Service Chaining VAS Filter Policy or select an existing VAS filter policy and click Properties. The Service Chaining VAS Filter Policy (Create|Edit) form opens.

Modifying an active VAS filter policy is potentially service-affecting. Ensure that you consider the implications of reconfiguring the policy before you proceed.


On the General tab, configure the Displayed Name and Description parameters.


Click on the VAS Filter Entries tab to configure filter entries for the policy.

  1. Click Create or select an existing filter entry and click Properties. The VAS Filter Entry (Create|Edit) form opens.

  2. Configure the required parameters.

    You must configure at least one of the Protocol, Foreign IP Address, or Foreign IP Address Prefix (with Mask and Port) parameters.

  3. Click on the Actions tab to configure filter actions.

    In order to configure filter actions, the filter entry Admin State must Out of Service.

  4. Click Create or select an existing action entry and click Properties. The VAS Filter Action (Create|Edit) form opens.

  5. Configure the required parameters.

    Only one Downstream action and one Upstream filter action can be created per filter entry.

  6. Save your changes and close the forms.


Click OK to save the policy and close the form, or click Apply to save the policy. See To release and distribute a policy to distribute the policy to NEs.

End of steps