To configure GTP on a VPRN site

Note: GTP must be enabled on the base router before it can be configured on a VPRN site; To configure GTP on a routing instance.

Steps
 

Choose Manage→Service→Services from the NFM-P main menu. The Manage Services form opens.


Choose a VPRN service and click Properties. The VPRN Service (Edit) form opens.


On the service navigation tree, expand Sites, right-click on a routing instance and choose Properties. The VPRN Site (Edit) form opens.


Set the Enable GTP Uplink parameter to Enabled.


Click on the GTP tab to configure S11 and uplink interfaces.


Click on the On the S11 tab to configure S11 interfaces and peer profile mappings:

  1. On the Interfaces tab, click Create. The S11 Interface (Create) form opens.

  2. Select an interface and an APN policy.

  3. Save the changes and close the form.

  4. Click on the Peer Profile Mapping tab and click Create. The S11 Peer Profile Mapping (Create) form opens.

  5. Configure the Address Prefix and Prefix Length parameters.

  6. Select a Peer Profile.

  7. Save the changes and close the form.


Click on the On the Uplink tab to configure an uplink interface and peer profile mappings:

  1. On the General tab, configure the APN Network Identifier and PDN Type parameters.

  2. Click on the Peer Profile Mapping tab and click Create. The Uplink Peer Profile Mapping (Create) form opens.

  3. Configure the Address Prefix and Prefix Length parameters.

  4. Select a Peer Profile.

  5. Save the changes and close the form.


Save the changes and close the forms.

End of steps