To configure a security host group policy for a 7705 SAR

Purpose

A host group policy is configured with single source/destination IP addresses or a range of IP addresses. For a single pre-assigned set of IP addresses that are allowed in a network, a list can be created once and assigned to every edge router. The host group policy can be assigned to a security policy.

Steps
 

Choose Policies→Security from the NFM-P main menu. The Security Policies form opens.


Click Create and choose Security Host Group, or choose an existing security host group policy and click Properties. The Host Group, Global Policy (Create|Edit) form opens with the General tab displayed.


Configure the required general parameters and click Apply.


Click on the Host Group Entries tab and click Create. The Host Group Entry, Global Policy form opens.


Configure the required general parameters and the parameters in the IP Address panel.


Save your changes. See To release and distribute a policy to release and distribute the policy to NEs.

End of steps