To create a segment routing tree

Purpose

Use this procedure to create a segment routing multicast tree for P2MP traffic engineering. The segment routing tree must be created on a routing instance of the NE that will serve as the root node.

A reserved label block is required; see To create a reserved label block.

Steps
 

In the navigation tree Routing view, expand Network→NE→Routing Instance. Right-click on a routing instance and select Properties.


Click on the Segment Routing tab.


Click on the SR-Tree tab and click Create. The Segment Routing Tree form opens.


Configure the required parameters in the General tab.


Click on the SR-Tree Replication Policies tab. Create segment routing tree replication policies by performing the following:

  1. Click Create. The Replication Segment Policy form opens.

  2. Configure the parameters in the General tab.

  3. Click on the Next Hop Entries tab and click Create. The Replication Segment Policy Next Hop form opens.

  4. Configure the parameters.

  5. Click OK to close the Replication Segment Policy Next Hop form. A next hop entry appears in the table.

  6. Create additional hops as needed.

  7. Click OK to close the Replication Segment Policy form. An SR-Tree Replication policy appears in the table.


Click on the SR-Tree Policies tab. Create segment routing tree policies by performing the following:

  1. Click Create. The Segment Routing Tree Policy form opens.

  2. Configure the parameters in the General tab.

  3. Click on the Candidate Paths tab and click Create. The Candidate Path form opens.

  4. Configure the parameters.

    The Active Instance parameter indicates the replication policy instance ID to be used.

  5. Click OK to close the Candidate Path form. A candidate path appears in the table.

  6. Create additional candidate paths as needed. The candidate path with the higher preference becomes the active candidate path.

  7. Click OK to close the Segment Routing Tree Policy form. An SR-Tree policy appears in the table.


Click OK and confirm to close the Segment Routing Tree form.

End of steps