CSC-1 Base station configuration information

CSC-1 Base station configuration information
		GO

General base station information

Complete the following cell site information:

Cell Site	information (provided by inspector)
Name
Address
Contact name
MTA name
Cell Site #
Contact Phone & Pager #

Document and drawings

Complete the information for the following reference documentation

Document or Drawing	Document #	Issue #
Alcatel-Lucent Installation Equipment Drawing(s)
Site Preparation Document
Base Station & Power Alarm Requirements
Base Station GPS Document
Base Station Cabinet Installation Manual
Lightning Protection and Grounding Guidelines

Installation type

Check all that apply:

□ Indoor

□ Outdoor

□ Controlled Environment

□ Uncontrolled Environment

□ Concrete Pad

□ Rooftop

□ Other (Specify):__________________

Base station sub-structure

Check all that apply:

□ Concrete

□ Wood floor

□ Raised floor

□ Non-Penetrating

□ I-beam

□ C-beam

□ Platform

Earthquake Zone Rating

Check one:

□ Zone 0

□ Zone 1

□ Zone 2

□ Zone 3

□ Zone 4

Base station equipment

Complete the information for the UMTS Macrocell equipment:

Cabinet Type	Serial #	# of sector	Duplex/ Triplex
Primary cabinet
Growth cabinet
Power cabinet
Battery cabinet

Antennas

Complete the following (if required):

PCS Channel # (1-3) __________________

# of Carriers (1) __________________

GPS Antenna KS/Model __________________

PCS Freq. Block (A-F) __________________

GPS Cable Length (ft.) __________________

GPS Antenna Gain (dB) __________________

Antenna Type (N-N or N-DIN) __________________

Quantity of Antenna Jumper Cables (1-15) __________________

Power

Total # of Battery Strings __________________

Power source

-48 VDC

+24 VDC

AC Generator Receptacle?

Yes

Power co-located with base station equipment?

Yes

Other Cell Site Equipment

Complete the following:

Equipment Description	Yes (Y)	No (N)	N/A
Antenna Tower?	Y	N	N/A
FAA Lighting?	Y	N	N/A
Tower Light Alarm?	Y	N	N/A
Ice Bridge? Covering: (check one) _________ Cables Only _________ Cables and Equipment	Y	N	N/A
Cable Tray or Ladder Racks? Type of Ladder: (check one) _________ 5' Ladders _________ 12' Ladders _________ Other: _________	Y	N	N/A
Antenna Cable Hatch Plate? Number of Entry Holes _________	Y	N	N/A
Facilities Ancillary Equipment? Power Source: (check one) _________ AC _________ DC Voltage: (check one) _________ DC _________ rms	Y	N	N/A
AC Service : Size (amps) _________ Voltage (v) _________ Phase (1 or 3) _________
Non-Alcatel-Lucent Power Plant? Note: If YES, the customer is responsible for the power plant's configuration	Y	N
Earthquake Bracing Required?	Y	N	N/A
Tx/Rx Antenna? (type and quantity) _________ Simplex Only (1-15) _________ _________ Simplex/Duplex (1-15) _________ _________ Duplex Only (1-6) _________ (mounting location) _________ Tower _________ Steel Structure _________ Building _________ Antenna Support Structure	Y	N	N/A
Cell Site Grounding? If YES, select all that apply: _________ Buried ring ground and driven rods _________ Buried metallic and electrically continuous water pipe _________ Down conductors (Quantity: _________) _________ Electrolytic ground rod(s) (Quantity:_________) _________ Driven ground rod(s) (Quantity:_________) _________ Grounded building steel _________ Ground grid _________ Ground radial(s) (Quantity:_________)	Y	N
Co-located non-PCS equipment? Existing grounding system: _________ Single Point _________ Integrated	Y	N
Ground Bus? If YES, quantity: _________	Y	N

Completed by: __________________

Date: _________

		GO
© Alcatel-Lucent