The following Warning includes the safety precautions, which must be observed when performing the site prep installation procedures covered in this document.
Failure to observe these safety precautions may result in personal injury or damage to equipment.
-
Read and understand all instructions.
-
Follow all warnings and instructions marked on this product.
-
Installation and maintenance procedures must be followed and performed by trained personnel only.
-
The equipment is intended for installation in restricted access locations where access is controlled or where access can only be gained by service personnel with a key or tool. Access to this equipment is restricted to qualified service personnel only.
-
Grounding and circuit continuity is vital for safe operation of the equipment. Never operate the equipment with grounding/bonding conductor disconnected.
-
Install only equipment identified in the product's installation manual. Use of other equipment may result in an improper connection which could lead to fire or injury.
-
Use caution when installing or modifying telecommunications lines.
-
The telecommunication interfaces should not leave the building premises unless connected to telecommunication devices providing primary and secondary protection, as applicable.
-
The product has multiple power inputs. Before servicing, Disconnect all inputs to reduce the risk of energy hazards.
-
For continued protection against risk of fire, all fuses used in this product must be replaced only with fuses of the same type and rating.
-
Never install metallic wiring during a lightning storm.
-
Never install telecommunications connections in wet locations.
-
Never touch uninsulated telecommunications wiring or terminals unless the telecommunications line has been disconnected at the interface.
-
Never touch uninsulated wiring or terminals carrying direct current or ringing current, and never leave this wiring exposed. Protect and tape uninsulated wiring and terminals to avoid risk of fire, electrical shock, and injury to personnel.
-
Never push objects of any kind into the product through slots, as they may touch dangerous voltage points or short-out parts that could result in a fire or an electrical short.
-
Never spill liquids of any kind on the product.
-
Slots and openings in the product are provided for ventilation. To protect it from overheating, these openings must not be blocked or covered. The product should not be placed in a built-in installation unless proper ventilation is provided.
-
To reduce the risk of an electrical shock, do not disassemble the product. Opening and removing covers and/or circuit boards may expose you to dangerous voltages or other risks. Incorrect reassembly can cause electrical shock when the unit is subsequently used.
