To configure an IEC/IEEE 61850-9-3 PTP clock on a 7705 SAR

Before you begin

You can only configure the IEC/IEEE 61850-9-3 PTP clock on a 7705 SAR with a CSM clock ID. Master clock is only supported for 7705 SAR devices with integrated GNSS. When you configure a 7705 SAR with the IEC/IEEE 61850-9-3 profile, the default settings are automatically applied.

Steps
 
1 

On the equipment tree, expand Network→NE→ Shelf→Synchronization→Clock 32.

2 

On the General tab, configure the PTP Profile parameter as IEC-61850.9.3.

3 

Configure the Clock Type parameter, as required.

Note: Master clock is only supported for 7705 SAR devices with integrated GNSS.

4 

Verify that the default values are correct for the following parameters: Domain, Network Type, Clock ID, Clock Announce Rx Timeout, and Clock Announce Interval.

5 

To turn up PTP ports on the IEC-61850.9.3 PTP clock:

  1. Click on the IEEE PTP Port tab. The IEEE 1588 PTP clock form opens.

  2. Select a port and configure the required parameters.

  3. Verify that the default values for the Cfg Sync Rate and Cfg Delay Req Rate parameters are configured as 1 pkt/sec.

  4. Save your changes.

6 

Save your changes and close the forms.

You can view the statistics for the PTP clock on the Statistics tab of the PTP clock form.

End of steps