To configure a virtual Ethernet port on a 7705 SAR 2-port ring MDA
Purpose
Perform this procedure to configure a virtual Ethernet port on a 7705 SAR 2 × 10-Gig Bridged Ethernet XFP + 1 × 2.5G Virtual Ethernet card on a 7705 SAR-8 and 7705 SAR-18. See To configure a QoS network policy for information about configuring a network policy of ring type for a 7705 SAR. See To configure an MDA for information about configuring a ring port on a 7705 SAR 2 × 10-Gig Bridged Ethernet XFP + 1 × 2.5G Virtual Ethernet card.
Steps
1 |
On the equipment tree, choose Network→NE→Shelf→Card Slot n→Daughter Card Slot n→Virtual Port n/n/n, where the virtual port is the port object you need to configure. |
2 |
Right-click on the Virtual Port icon and choose Properties. The Virtual Port (Edit) form opens. |
3 |
Configure the required parameters. |
4 |
Click on the States tab and configure the Administrative State parameter. |
5 |
Click on the Policies tab. |
6 |
Select a network queue policy. |
7 |
Click on the Ethernet tab and configure the required parameters. You must configure the Down When Looped parameter value as Enabled to see the Down When Looped Configuration panel parameters. |
8 |
Click on the Network Interfaces tab to create a network interface on the virtual Ethernet port. |
9 |
Click Add. The Create Network Interface - Routing Instance form opens. See To create an L3 network interface on a routing instance for information on creating a network interface. Note: You can only bind a virtual Ethernet port to a network interface. |
10 |
Save your changes and close the form. End of steps |