To create a standard VLAN service on OmniSwitch devices

Note: Nokia recommends that you specify the OmniSwitch ports that will be network interfaces before you configure a standard VLAN service.

Steps
 
1 

Choose Create→Service→VLAN from the NFM-P main menu. The VLAN (Create) Service form opens.

2 

Select a customer to associate with the VLAN.

3 

Configure the required general parameters.

The Service ID and SVC Mgr Service ID parameters are configurable when the Auto-Assign ID parameter is disabled.

4 

Click on the VLAN tab and set the Application parameter to Standard VLAN.

5 

Select a group to associate with the VLAN in the Group panel.

6 

On the service navigation tree, right-click on VLAN and choose Create VLAN Site to choose a site for the VLAN. The Site (Create) form opens.

7 

Configure the required general parameters.

8 

Click on the VLAN tab and configure the required parameters.

9 

Perform To associate an access interface with a VLAN service to create one or more access interfaces on the site.

10 

To enable DHCP/DHCPv6 snooping on the VLAN:

  1. Click on the DHCP/DHCPv6 Snooping tab.

  2. Click Create. The VLAN Level DHCP/DHCPv6 Snooping (Create) form opens.

  3. Configure the required parameters.

    These parameters are automatically enabled when DHCP/DHCPv6 snooping is enabled on a VLAN.

  4. Save the changes and close the form.

11 

To add one or more static entries to the DHCP binding table:

  1. Click on the Binding Database tab.

  2. Click Create. The DHCP Snooping Binding Database (Create) form opens.

  3. Configure the MAC Address parameter.

  4. Select a port.

  5. Configure the required parameters.

  6. Save the changes and close the form.

12 

Save the changes and close the forms.

End of steps