To configure a 9500 Radio Interface Queue Map policy

General information

When configuring a 9500 Radio Interface Queue Map policy, the following QoS variants are supported: ODU, MPT-HL, and MPT-HC/MPT-MC.

Steps
 
1 

Choose Policies→QoS→9500 MPR QoS→ 9500 Radio Interface Queue Map from the NFM-P main menu. The 9500 Radio Interface Map Policies form opens.

2 

Perform one of the following:

  1. Configure the Policy scope parameter to Global. Go to Step 3.

  2. Configure the Policy scope parameter to Local.

    If required:

    1. Click Select to configure the Local Node IP Address parameter. The Select a Network Element form opens.

    2. Choose a device and click OK. The 9500 Radio Interface Map Policies form reappears.

3 

Click Create. The 9500 Radio Interface Queue Map, Global Policy (Create) form opens.

4 

Configure the parameters as required.

5 

Click on the Radio Interface Queue Map tab and click Create. The Radio Interface Queue Map, 9500 Radio Interface Queue Map Global Policy (Create) form opens.

6 

Configure the parameters as required and click OK. The 9500 Radio Interface Queue Map, Global Policy (Create) form reappears.

Note: You cannot configure the queue size parameters when the Reset all Queues parameter is selected.

Note: The Queue Size parameter configuration must be limited to a maximum of 4034836 bytes and a minimum of 2480 bytes.

7 

Save your changes and close the form. The 9500 Radio Interface Map Policies form reappears.

8 

Click Search to display the created policy. To distribute the 9500 Radio Interface Map policy, see the “Policies overview” chapter in the NSP NFM-P Classic Management User Guide.

End of steps