| |
|
1 |
Choose Tools→Bulk Operations from the NFM-P main menu. The Bulk Operations form opens.
|
2 |
Click Create. The Create Bulk Change step form opens.
|
3 |
Configure the required parameters in the General step and click Next. The Specify the filter step appears.
|
4 |
Configure an appropriate filter in the Specify the filter step and click Next. The Specify the attributes step appears.
|
5 |
Expand the Attributes drop-down, and click on one or more attributes, as required. The PM properties are displayed on the right panel.
|
6 |
Configure the parameters in the right panel. The following notes apply:
- For radio interfaces, do not use the following attributes:
-
Radio: Radio Port (Radio Equipment)→Radio PM : Radio Port (Radio Equipment)→Radio PM.
The configured filter lists only the enabled radio PM statistics and not the disabled radio PM statistics.
-
Radio: Radio Port (Radio Equipment)→Radio PM : Radio Port (Radio Equipment)→Radio Bulk Radio PM Enable/Disable 15 Min
-
Radio: Radio Port (Radio Equipment)→Radio PM : Radio Port (Radio Equipment)→Radio Bulk Radio PM Enable/Disable 24 Hrs
- For DS1/E1:
-
PM Enable/Disable for DS1 ports is supported only for Framed and
Unframed signal mode ports.
-
PM Enable/Disable for E1 ports is supported only for Framed signal mode ports.
|
7 |
Click Next, then click Finish, and close the form. The Bulk Operations form reappears.
|
8 |
Click Search to locate the Bulk Operation task, choose an entry, and click Properties. The Bulk Change (Edit) form opens.
|
9 |
Click on the Batch Control tab and click Generate Batches. The batches are generated.
|
10 |
Either click Execute All or choose the required entries and click Execute Selected to enable or disable PM statistics collection intervals of 24 hour and/or 15 min.
|
11 |
Close the forms.
End of steps |