How do I create a classic reachability policy?

Purpose

Use this procedure to create a management ping policy to specify how the NSP checks the connection to device management IP addresses on classic devices.

Note: You must enable scheduling for a ping policy to be active. When scheduling is not enabled, and an assigned managed device is not reachable, management connection alarms may not be raised.

During creation of a discovery rule, reachability policies are assigned for in-band management, out of band management, and CPM. address reachability.

Steps
 
1 

Open Device Discovery, Reachability Policies.

The system displays the list of configured reachability policies.

2 

Click png2.png REACHABILITY POLICY.

3 

In the form that opens, click the Classic Reachability check box.

4 

Configure the required parameters.

Parameter

Description

Policy Name

The name of the Reachability policy

Classic Policy ID

Enter a policy ID or click the Auto assign policy ID check box.

Timeout (seconds)

Specifies the length of time, in seconds, to wait for a response after attempting to reach the NE

Schedule enabled

Schedule enabled means the policy is in effect.

Interval

Specifies the length of time, in minutes and seconds, to wait before repeating an attempt to reach the NE

5 

Click CREATE. The reachability policy is added to the list.

End of steps