To enable the NSP crypto-policy function on a manually installed RHEL OS

Perform this procedure to configure the minimum RSA cryptography key length for the RHEL crypto-policy function on a NSP OS instance.

Note: The crypto-policy function is not enabled on the OS until you perform the procedure.

Note: You must perform the procedure before you install any NSP software on the OS.


1	Log in as the root user on the station that hosts the OS.
2	Open a console window.
3	Enter the following: `#` `cat /etc/crypto-policies/config ↵` The following crypto-policy setting is displayed: `DEFAULT`
4	Create the following file using a plain-text editor such as vi: /etc/crypto-policies/policies/modules/NSP_CUSTOM_RSA_SIZE.pmod
5	Edit the file to read as follows: `min_rsa_size = 2048`
6	Save and close the file.
7	Enter the following: `#` `cat NSP_CUSTOM_RSA_SIZE.pmod ↵` The edited file is displayed.
8	Ensure that the file reads as follows: `min_rsa_size = 2048`
9	Enter the following: `#` `update-crypto-policies --set FUTURE:NSP_CUSTOM_RSA_SIZE ↵` Messages like the following are displayed. `Setting system policy to FUTURE:NSP_CUSTOM_RSA_SIZE` `Note: System-wide crypto policies are applied on application start-up.` `It is recommended to restart the system for the change of policies to fully take place.` If the output is as shown, the crypto-policy configuration is successful.
10	If the crypto-policy configuration succeeds, enter the following: `#` `systemctl reboot ↵` The station reboots.
11	Log in as the root user.
12	Open a console window.
13	Enter the following: `#` `cat /etc/crypto-policies/config ↵` The crypto-policy setting is displayed.
14	Verify that the crypto-policy setting reads as follows: `FUTURE:NSP_CUSTOM_RSA_SIZE`
15	Close the console window. End of steps