How do I create a service tunnel?

Purpose

Use this procedure to create a new service tunnel. Brownfield service tunnels, created previously in NFM-P or on MDM-managed nodes, can be discovered by NSP and used by services, but their properties cannot be modified from the NSP's service management views. They can, however, have steering parameters applied to them, and have workflows executed on them.

The parameters that are available to you during service tunnel creation is dependant on the intent type that is associated with the tunnel template you select, and may differ from those described in this procedure, which assumes the Nokia-provided tunnel template is being used.

Steps
 
1 

Perform How do I create a service template?.

2 

Perform one of the following:

    1. From the Service Management, Service Tunnels view, click + CREATE.

      The Select a tunnel template to start form opens displaying a list of tunnel templates.

    2. Click on a tunnel template from the list.

      The Create Tunnel form opens with the Template Name parameter populated.

    1. During service creation, click on the SDP ID field, then click + CREATE TUNNEL.

      The Create Tunnel form opens.

    2. Click on the Template Name field and select a tunnel template from the list.

3 

Configure the parameters, as required:

Parameter

Description

Source NE ID

Specifies the identifier of the source NE

SDP ID

Specifies the SDP IP

Name

Specifies the name of the tunnel

Destination NE ID

Specifies the identifier of the destination NE

Description

Describes the tunnel

Admin State

Specifies the initial administrative state of the tunnel upon deployment

Transport Type

Specifies the type of transport to be used by the tunnel, MPLS or GRE

Signaling

Specifies the signaling method to be used by the tunnel

MTU

Specifies the MTU of the tunnel

Metric

Specifies the metric of the tunnel

4 

If the Transport Type parameter was set to MPLS, configure the required parameters:

Parameter

Description

Mixed LSP Mode

Specifies whether mixed LSP mode is enabled for the tunnel

Revert Time

Specifies the revert time, when mixed LSP mode is enabled

Enable LDP

Specifies whether LDP is enabled for the tunnel

Enable BGP Tunnel

Specifies whether BGP tunnel is enabled for the tunnel

SR-ISIS

Specifies whether SR-ISIS is enabled for the tunnel

SR-OSPF

Specifies whether SR-OSPF is enabled for the tunnel

LSP

Specifies the LSP to be associated with the tunnel

5 

Configure the required Hello parameters:

Parameter

Description

Keep Alive Enabled

Specifies whether keep alive is enabled for the tunnel

Hello Time

Specifies the hello time of the tunnel

Hello Message Length

Specifies the hello message length of the tunnel

Hello Request Timeout

Specifies the hello request timeout of the tunnel

Hold Down Time

Specifies the hello down time of the tunnel

Max Drop Count

Specifies the maximum drop count of the tunnel

6 

If the Transport Type parameters was set to GRE, configure the Allow Fragmentation parameter (if required), which specifies whether or not fragmentation will be allowed for the tunnel.

7 

Configure the required parameters:

Parameter

Description

Steering Parameters

Specifies the steering parameter(s) to be associated with the tunnel

Tunnel Admin Group

Specifies the administrative group to which the tunnel will belong

8 

Perform one of the following:

  1. Select the Reserve Resources check box and click PLAN to create the tunnel in a Planned state.

  2. Click SAVE to create the tunnel in a Saved state.

  3. Click DEPLOY to create the tunnel in a Deployed state.

See What is Life Cycle State? for more information.

End of steps

© 2024 Nokia. Nokia Confidential Information

Use subject to agreed restrictions on disclosure and use.