To configure a NAT classifier

Purpose

Perform this procedure to configure a NAT classifier for use in a destination NAT (DNAT) configuration.

Steps
 
1 

Choose Policies→ISA Policies→NAT Classifiers from the NFM-P main menu. The NAT Classifiers form opens.

2 

Click Create or select an existing NAT classifier and click Properties. The NAT Classifier (Create|Edit) form opens.

3 

Configure the required parameters.

If the Default Action parameter is set to DNAT, you can configure the Default Action Address parameter, the Default DNAT Address parameter, or both.

4 

Click on the Classifier Entries tab to configure NAT classifier entries. You can configure up to 32 classifier entries.

  1. Click Create or select an existing classifier entry and click Properties. The NAT Classifier Entry (Create|Edit) form opens.

  2. Configure the required parameters.

    If the Action parameter is set to DNAT, you must configure the DNAT Address parameter, unless the Default DNAT Address parameter was configured in Step 3.

  3. Save your changes and close the form.

5 

Save your changes and close the forms. See To release and distribute a policy to distribute the policy to NEs.

End of steps