To configure segment routing with IPv6

Steps
 
1 

In the navigation tree Routing view, expand Network→NE→Routing Instance. Right-click on a routing instance and select Properties.

2 

Click on the Segment Routing tab.

3 

Create or select an entry in the SRv6 tab and click Properties. The Segment Routing V6 (Create/Edit) form opens.

4 

Create or select an entry in the Locators tab and click Properties. The SRv6 Locator (Create/Edit) form opens.

5 

Configure the required parameters in the General tab.

  1. Associate FPE ID under FPE block. See To create an FPE for more information on FPE.

    Note: The associated Termination FPE must have SRv6 Type set as Termination. Similarly, Origination FPE must be configured with SRv6 Type as Origination.

  2. Under Prefix panel, specify the network address for the Prefix Address parameter.

  3. Associate a label block under Static Function panel.

    Note: The configuration of FPE ID, Prefix Address, and parameters under Static Function panel are required to set the Administrative State parameter to Up.

  4. Save your changes and close the form.

6 

On the Segment Routing V6 (Create/Edit) form, configure the required parameters in the General tab.

7 

Create or select an entry in the Base Routing Instance panel and click Properties. The SRv6 Function (Create/Edit) form opens.

8 

Configure the required parameters in the General tab.

  1. Associate a locator under Locator panel.

  2. Configure parameters under End Function panel.

    Supported End Function types are Dynamic and Static.

9 

Configure the End Function, the End-X Function, and the End -X Allocate Function in respective tabs.

Note: End (End DT4, End DT6, End DT46, End-X) Functions range configuration is dependent on the max entries configured in static function.

10 

Save your changes and close the forms.

End of steps