To configure a module card on a 7705 SAR-M/ME or 7705 SAR-H

Steps
 
1 

On the equipment tree, right-click on a 7705 SAR-M/ME or 7705 SAR-H NE and choose Properties. The Network Element (Edit) form opens.

2 

On the NE navigation tree, expand Shelf→Card Slot n, right-click on the applicable Daughter Card Slot object and choose Configure Daughter Card. The Daughter Card Slot (Create) form opens.

Note: For the 7705 SAR-M and 7705 SAR-ME, only the third daughter card slot can be configured with module cards. The first two daughter card slots are configured with integrated cards.

For the 7705 SAR-H, only the second and third daughter card slots can be configured with module cards. The first daughter card slot is configured with an integrated card.

3 

Configure the Assigned Daughter Card Type parameter.

4 

Click Apply. The Daughter Card Slot form refreshes.

5 

Click on the Daughter Card tab and configure the required parameters.

6 

To add a fabric profile:

  1. Select a fabric profile in the Network Ingress Fabric Profile panel.

  2. Select a fabric profile in the Access Ingress Fabric Profile panel.

    If you are configuring a 1 Colour Optical Add/Drop Mux card, go to Step 21 .

7 

Select a network queue policy in the Network Policy Queue panel, if required.

8 

Click on the Ports tab.

9 

Click on a port and choose Properties. The Physical Port (Edit) form opens.

Note: The first port on the DCM includes four SHDSL lines. The second port includes two XDSL lines.

10 

Configure the required parameters.

11 

Click on the States tab and configure the Administrative State parameter. If you are configuring a DSL or DCM module, go to Step 13 .

12 

Click on the GPON tab and configure the required parameters. Go to Step 21 .

13 

Click on the DSL tab and configure the required parameters.

14 

To configure XDSL or SHDSL lines:

  1. Click on the XDSL or SHDSL tab, as required.

  2. Choose an XDSL or SHDSL line and click Properties. The XDSL Line (Edit) or SHDSL Line (Edit) form opens.

  3. Configure the Administrative State parameter.

  4. Save the configuration and close the form.

  5. To configure more lines, repeat 1 to 4 .

15 

Click on the Ethernet tab and configure the required parameters on the General tab.

16 

Click on the EFM-OAM tab. To configure the parameters on this tab, perform the steps provided in To configure an 802.3ah EFM OAM diagnostic test from an NE Properties form .

17 

Click on the LLDP tab and configure the required parameters on the Nearest Bridge, Nearest Customer, and Nearest Non TPMR tabs.

18 

Click on the Remote Peers tab under the LLDP tab to search for and display LLDP remote peers associated with the port. These remote peers are used to determine the physical topology of the network.

19 

Click on the 802.1x Port and 802.1x Port Authenticator tabs, and configure the required parameters.

20 

If you are configuring a 6 port Ethernet module card, click on the PoE tab and configure the required parameters.

21 

Save your changes and close the forms.

End of steps