Enable and configure SNMP on the device.

1. See To commission a device for NFM-P management for NFM-P natively-managed devices.

2. See To commission an OmniSwitch for NFM-P management for the OmniSwitch.

If required, configure the source of device SNMP traps; see To configure the NFM-P SNMP trap sources .

If required, use a CLI to enable NFM-P in-band management of the device by to configure a second trap destination and trap log on the device. See GNE commissioning for information about in-band management. See the device documentation for configuration information.

If required, establish a route for in-band traffic. For example, to configure a static route or use OSPF. See Chapter 27, NE routing and forwarding for more information on static routes. See Chapter 28, Routing protocol configuration for more information about OSPF.

Configure the NFM-P to use in-band polling, out-of-band polling, or in-band and out-of-band polling for the device. An NFM-P mediation policy specifies the polling interval. See Chapter 9, Device discovery for information about mediation policies.

1. For 7450 ESS, 7705 SAR, 7750 SR, and 7950 XRS polling configuration information, see To configure polling for a 7250 IXR, 7450 ESS, 7705 SAR, 7750 SR, 7950 XRS, VSR, or Wavence SM

2. For 7210 SAS polling configuration information, see To configure polling for a 7210 SAS .

3. For 7705 SAR-Hm polling configuration information, see To configure polling for a 7705 SAR-Hm .

4. To edit polling settings for multiple managed devices, see To edit polling settings for multiple devices .