To configure a WLAN GW group

Steps
 
1 

On the Equipment tree, expand Network→NE→Logical Groups→ISA-WLAN GW Groups.

2 

Right-click on the ISA-WLAN GW Groups icon and choose Create ISA-WLAN GW Group, or right-click an existing ISA-WLAN GW Group object and choose Properties. The ISA-WLAN GW Groups (Create|Edit) form opens.

3 

Configure the required parameters.

The LSN Support parameter in the NAT panel is only configurable when the ISA WLAN GW group is in the Shut Down state.

4 

Select a port policy.

5 

Select a tunnel port policy.

6 

Select a NAT RADIUS accounting policy in the NAT panel, if required.

7 

Select an ISA-AA group in the Distributed Subscriber Management panel, if required.

8 

Click Apply. The ISA-WLAN GW Group form refreshes with additional tabs.

9 

Click on the ISA-IOMs tab.

  1. Click Create or select an existing IOM entry and click Properties. The ISA-WLAN GW Group IOM (Create|Edit) form opens.

  2. Select the ISA-WLAN GW group member IOM card.

  3. Repeat 1 and 2 to configure additional LNS group members, if required.

10 

Click on the Watermarks tab to configure high/low watermark entries for the ISA-WLAN GW group.

  1. Click Create or select an existing watermark entry and click Properties. The WLAN-GW Group Watermark (Create|Edit) form opens.

  2. Specify the entity type to monitor.

  3. Configure the High Watermark and Low Watermark percentage for the entity type.

11 

Save your changes and close the forms.

End of steps