To create a LAG link mapping profile

Note: You can only use LAG link mapping profiles on an NE that is in chassis mode D or higher.

Steps
 
1 

On the equipment navigation tree, expand Network→NE→Logical Groups→LAGs→LAG n.

2 

Right-click on the LAG n object and choose Properties. The LAG (Edit) form opens.

The following table describes the required parameter values that must be set in order to use LAG link mapping profiles.

Table 13-1: LAG link mapping prerequisites

Tab

Parameter

Required values

General

Port Type

Access or Hybrid

Access

QoS Adaptation

Link

LAG Members

Sub-Group ID

All LAG members must be in the same sub-group.

3 

Click on the Link Mapping Profiles tab and click Create. The Link Mapping Profile (New Instance) form opens.

Configure general profile parameters
 
4 

Configure the required parameters on the General tab.

Create mapping profile links
 
5 

Click on the Mapping Profile Links tab and click Create. The Link Mapping Profile Link (New Instance) form opens.

6 

Click Select and specify a port. The selected port will be used for egress traffic for interfaces assigned to this LAG link mapping profile.

7 

Configure the Type parameter.

8 

Save your changes and close the form.

9 

Configure a secondary port by repeating Step 5 to Step 8 , if required.

Assign the link mapping profile to an interface or MSAP policy, if required
 
10 

Assign the LAG link mapping profile to a network interface, access interface, or SAP, if required:

  1. Click on the Network Interface, L2 Access Interface, L3 Access Interface, or Service Access Points tab. A list of interfaces that terminate on the LAG appears.

  2. Select an interface from the list and click Properties. The Interface (Edit) form appears.

  3. Click on the Port tab.

  4. Select a LAG link mapping profile.

  5. Save your changes and close the form.

11 

Assign the LAG link mapping profile to an MSAP policy, if required:

  1. From the NFM-P main menu, select Policies→Residential Subscriber. The Residential Subscriber Policies form opens.

  2. Select an MSAP policy from the list and click Properties. The MSAP Policy (Edit) form opens.

  3. Click on the Local Definitions tab.

  4. Select the local definition for the site where the LAG link mapping profile is configured, and click Properties. The MSAP Policy (Local Policy) form opens.

  5. If the Distribution Mode parameter is set to Sync With Global, click Switch Mode.

  6. Set the LAG Link Map Profile parameter to the ID of the LAG link mapping profile you need to assign to the MSAP policy.

  7. Save your changes and close the forms.

End of steps