To create an LSP template MVPN policy

Purpose

This procedure defines the template used to create LSPs across a multicast VPN. The LSP template MVPN policy can be configured locally on a specific NE or globally across the network.

The following can be created:

P2MP
one-hop P2P
mesh P2P
one-hop P2P SR TE
mesh P2P SR TE
OnDemand P2P SR TE

If you need to use entropy labels, the type must be One-Hop P2P LSP or Mesh P2P LSP.

Steps


1	Choose Policies→MPLS→LSP Template MVPN from the NFM-P main menu. The LSP Template MVPN Policies form opens.
2	Perform one of the following: Configure the Policy scope parameter to Global. Configure the Policy scope parameter to Local and click on the Select button to choose a device.
3	Click Create. The LSP Template MVPN Policy (Create) form opens.
4	Configure the parameters.
5	Click on the Properties tab. Note: The panels and parameters that appear in the Properties tab can vary based on configuration.
6	Configure the required parameters.
7	Click on the PCE-Associations tab. A list of LSP Template PCE associations is displayed. Perform one of the following: Create an LSP Template PCE Association. Use the following steps: Click Create. The MPLS LSP Template PCE-Association form is displayed. Select the Association type (Diversity or Policy). Select the pre-configured Associations from the list. Save your changes and close the form. Configure an existing LSP Template PCE Association. Use the following steps: Choose an LSP Template PCE Association and click Properties. The MPLS LSP Template PCE-Association (Edit) form opens. Configure the required parameters. Save your changes and close the form.
8	Click on the Accounting tab.
9	Configure the parameters.
10	Click on the Administrative Groups tab.
11	Assign one or more MPLS administrative groups to the LSP template MVPN policy. Use the following steps: Choose the required Included Groups in the Unassigned list. Click on the right arrow button. The groups are assigned to the LSP and moved to the Assigned list for inclusion. Choose the required Excluded Groups in the Unassigned list. Click on the right arrow button. The groups are assigned to the LSP and moved to the Assigned list for exclusion. After you assign the Included and Excluded Groups, the total value of the groups is displayed in a bit mask format by the Groups Included and Groups Excluded indicators on the LSP Template MVPN Policy Properties tab.
12	Click OK to apply the changes. The LSP Template MVPN Policy, Global Policy (Create) form closes and the LSP Template MVPN Policies form reappears with the LSP MVPN template displayed.
13	Re-select the LSP MVPN template and click Properties. The LSP Template MVPN Policy - Global Policy (Edit) form opens.
14	Click on the Switch Mode button to distribute the policy locally to devices. See To release and distribute a policy to distribute the policy to NEs. Note: The MVPN LSP template cannot be used until you choose a default MPLS path and configure the Administrative parameter in a local policy definition after the global policy is distributed. After the changes are applied to the local policy, the policy can be switched back to Sync With Global mode and the local changes are saved.
15	Click on the Local Definitions tab.
16	Select an LSP MVPN template and click Properties. The LSP Template MVPN Policy, Local Policy (Edit) form opens.
17	Click on the Switch Mode button to change the configuration mode to Local Edit Only.
18	Click on the Properties tab.
19	Click on the Select button to choose a default MPLS path. The Select Default MPLS Path - Lsp MVPN Template, Local Policy form opens with a list of default MPLS paths displayed.
20	Choose an MPLS path and click OK. The default MPLS path is displayed.
21	Click on the General tab.
22	Configure the Administrative parameter.
23	Save your changes and close the form. End of steps