To configure a VPLS SAP template policy

Steps
 
1 

Choose Manage→Service→SAP Template Policies from the NFM-P main menu. The Manage Service SAP Template Policies form opens.

2 

Click Create→VPLS SAP Template or select an existing VPLS SAP template policy and click Properties. The VPLS SAP Template (Create|Edit) form opens.

3 

On the General tab, configure the required parameters.

An epipe SAP template policy cannot share the same object name as a VPLS SAP template policy if both policies are distributed to the same NE. Although both policies could co-exist in the NFM-P database, the NE stores both policy types in the same MIB table, which would cause a conflict.

4 

Select a DoS protection policy, if required.

If you configure a DoS protection policy on the VPLS SAP template policy, you can configure the CPM Monitor MAC parameter or select ETH CFM Monitoring options.

5 

Click on the Ingress tab to configure ingress filter, QoS, and scheduler policies for the VPLS SAP template policy.

  1. Select the following policy types, as required:

    • IP filter

    • IPv6 filter

    • MAC filter

    • QoS

    • QoS scheduler

    • Policer control

  2. Configure the remaining parameters.

6 

Click on the Egress tab to configure egress filter, QoS, and scheduler policies for the VPLS SAP template policy.

  1. Select the following policy types, as required:

    • IP filter

    • IPv6 filter

    • MAC filter

    • QoS

    • QoS scheduler

    • Policer control

  2. Configure the remaining parameters.

7 

Click OK to save the policy and close the form, or click Apply to save the policy. See To release and distribute a policy to distribute the policy to NEs.

End of steps