To configure an MSAP policy

Steps
 
1 

Choose Policies→Residential Subscriber from the NFM-P main menu. The Residential Subscriber Policies form appears.

2 

Click Create→MSAP Policy or choose an existing MSAP policy and click Properties. The MSAP Policy (Create|Edit) form opens.

3 

Configure the required parameters.

4 

Click on the Security tab to configure security policies on the MSAP Policy.

  1. Select an NE DoS protection policy to associate with the MSAP policy.

  2. Configure the MAC Monitoring and IP Src Monitoring parameters.

  3. Select an NE DDoS protection policy to associate with the MSAP policy.

5 

Click on the Subscriber Management tab to configure subscriber management parameters on the MSAP policy.

  1. Configure the required parameters.

  2. On the Policies panel, select the following policy objects:

    • default subscriber profile

    • default SLA profile

    • subscriber identification policy

  3. On the Default Application Profile panel, select a default application profile.

  4. On the Single Subscriber Configuration panel, select the following policy objects:

    • Non-Subscriber Traffic Subscriber Profile

    • Non-Subscriber Traffic SLA Profile

  5. On the Non-Subscriber Traffic Application Profile panel, select a non-subscriber traffic application profile.

6 

Click on the ATM tab.

  1. Configure the ATM OAM Alarm Cell Handling and Periodic ATM OAM Loopback parameters.

  2. Select an ingress ATM policy.

  3. Select an egress ATM policy.

7 

Perform the following, as required:

  1. If the MSAP policy is for an MSAP on a VPLS, click on the VPLS Only Configuration tab.

    1. On the General tab, configure the required parameters.

      An egress multicast group policy cannot be applied to SR NE variants at Release 15.0 R1 and higher.

    2. Select an egress multicast group policy.

    3. Select an access Ingress policy.

    4. Select an access Egress policy.

    5. Click on the DHCP tab and configure the required parameters.

    6. Click on the IGMP Snooping tab and configure the required parameters.

    7. Select a multicast CAC policy.

  2. If the MSAP policy is for an MSAP on an IES or VPRN, click on the IES VPRN Only Configuration tab.

    1. Set the Anti-Spoofing parameter to be Source IP and MAC Address.

    2. Configure the Ingress Queuing Type parameter.

    3. Select an access Ingress policy.

    4. Select an access Egress policy.

  3. Click on the VPLS Multicast CAC Constraints tab.

    1. On the LAG Port Down tab, click Create or select an existing multicast CAC Lag entry and click Properties. The Multicast CAC Lag Entry (Create|Edit) form opens.

      Up to eight Multicast CAC LAG entries can be created for an MSAP policy

    2. Configure the Number of Ports Down and Level ID parameters:

    3. Save your changes and close the form.

    4. Click on the Levels tab.

      Up to eight Multicast CAC Level entries can be created for an MSAP policy.

    5. Click Create or select an existing muliticast CAC level entry and click Properties. The Multicast CAC Level (Create|Edit) form opens.

    6. Configure the Level ID and Bandwidth parameters:

      The Bandwidth range is 1 to 4 294 967 952 for an MSAP policy.

    7. Save your changes and close the form.

  4. Click on the IGMP Host Tracking tab and configure the required parameters.

8 

Click OK to save the policy and close the form, or click Apply to save the policy. See To release and distribute a policy to distribute the policy to NEs.

End of steps