To configure a distributed subscriber management IP filter policy

Steps
 
1 

Choose Policies→Residential Subscriber from the NFM-P main menu. The Residential Subscriber Policies form opens.

2 

Click Create→Distributed Subscriber Management IP Filter Policy or select an existing policy item and click Properties. TheDistributed Subscriber Management IP Filter Policy (Create|Edit) form opens.

Modifying an active distributed subscriber management IP filter policy is potentially service-affecting. Ensure that you consider the implications of reconfiguring the policy before you proceed.

3 

Configure the required parameters.

4 

Click on the IPv4 Filter Entries tab to configure IPv4 filter entries.

5 

Click Create to create a new filter entry or select an existing filter entry and click Properties. The DSM IPv4 Filter Entry (Create|Edit) form appears.

  1. Configure the required parameters.

    The Port parameter is configurable if the Protocol parameter is set to TCP or UDP.

  2. Save your changes and close the form.

6 

Click on the IPv6 Filter Entries tab to configure IPv6 filter entries.

7 

Click Create to create a new filter entry or select an existing filter entry and click Properties. The DSM IPv6 Filter Entry (Create|Edit) form appears.

  1. Configure the required parameters.

    The Port parameter is configurable if the Protocol parameter is set to TCP or UDP.

  2. Save your changes and close the form.

8 

Click OK to save the policy and close the form, or click Apply to save the policy. See To release and distribute a policy to distribute the policer to NEs.

End of steps