To create a static configuration for a SRLG Policy

General Information

This procedure differs from the standard SRLG policy configuration described in To configure a Shared Risk Link Group policy by allowing you to manually enter the SRLG membership into the SRLG database for links in the entire network.

Steps
 
1 

Choose Policies→MPLS→Shared Risk Link Group Static Configuration from the NFM-P main menu. The Shared Risk Link Group Static Configuration Policies form opens.

2 

Click Create or choose a policy and click Properties. The Static Configuration for SRLGs Policy form opens.

3 

Configure the required parameters on the General tab.

4 

Click Apply to save the policy.

The Static Configuration for SRLGs Policy form is refreshed and the tabs become selectable. The following table describes the tabs that you can choose to configure parameters or view fault information.

Table 54-8: Description of Static Configuration for SRLG Policy form tabs

Tab

Description

Local Definitions

Lists Static Configuration for SRLG policies and allows you to manage policy distribution.

Routers

Lists and allows you to manage existing static configuration entries or add new ones.

Faults

List and manage alarms related to the static configuration for SRLGs.

5 

Click on the Routers tab and click Create. The Router for Static Config for SRLG policy form opens.

6 

Configure the required parameters.

7 

Save your changes and close the form. The router(s) you added appears in the list on the Routers tab.

8 

Repeat Step 5 to Step 7 if you need to add other routers, otherwise, go to Step 9 .

9 

Select one of the routers and click Properties. The Router for Static Config for SRLG policy form opens.

10 

Configure the Admin State parameter if required.

11 

Click on the Interfaces tab and click Create. The Static Configuration for SRLGs Policy, Global Policies form opens.

12 

Configure the required parameters.

Note: You can associate the same Interface Ip Address parameter with more than one SRLG.

13 

Click Apply and repeat Step 9 to Step 12 to add other entries or save your changes and close the form. See To release and distribute a policy to release and distribute the policy to NEs.

Note: A routing policy is discovered as local edit only. To synchronize a routing policy with all NEs, you must change the distribution mode of the routing policy to sync with the global policy. See To change the distribution mode of a policy to change the distribution mode of a routing policy.

End of steps