To configure a 7210 Port Access Ingress Policy

Purpose

7210 Port Access Ingress Policy allows you to access ports as layer 2 uplinks. As a result, you can apply a single port-based access-ingress policy on ingress of an access port instead of using per SAP ingress policies. This allows a single policy definition to be used to classify and rate-limit all traffic received over access ports.

Meters are mapped to FCs according to the user-defined configuration in the policy. The maximum number of meters supported on a local policy varies depending on the chassis type.

Steps
 
1 

Choose Policies→QoS→SROS QoS→Access Ingress→7210 Port Access Ingress Policy from the NFM-P main menu. The 7210 Port Access Ingress form opens.

2 

Click Create or choose an existing policy and click Properties. The 7210 Port Access Ingress Policy (Create|Edit) form opens.

3 

Configure the required parameters on the General tab.

4 

Configure ingress meters.

The Number of QoS Classifiers parameter, configured in Step 3 , affects the number of meters available.

Perform the following:

  1. Click on the Meter tab.

  2. Select a meter and click Properties, or click Create. The Meter form opens.

  3. Configure the required parameters on the General tab.

    You cannot choose ID values 1 or 9 for user-configured meters; these ID values are used by default meters.

  4. Configure the CIR/PIR parameters:

    1. Click on the CIR/PIR tab.

    2. Configure the required parameters.

  5. Configure the Burst Size parameters:

    1. Click on the Burst Size tab.

    2. Configure the required parameters.

      The parameters are configurable when the Default check box above each is deselected.

    3. Click OK.

5 

Click on the Forwarding Classes tab.

6 

Click Create or choose an existing forwarding class and click Properties. The Forwarding Class

(Create | Edit) form opens.

7 

Configure the required parameters and click OK.

8 

Click OK to save the policy and close the form, or click Apply to save the policy. See To release and distribute a policy to distribute the policy to NEs.

End of steps