In the navigation tree Routing view, expand Network→NE→Routing Instance. Right-click on a routing instance and select Properties.

Click on the Segment Routing tab.

Select the SR policy entry in the SR Policy tab and click Properties. The Segment Routing Policy form opens.

Configure the required parameters in the General tab.

To enable ingress statistics collection, perform the following:

1. In the Statistics Configuration panel, click Create. The Segment Routing Policy Statistics Configuration form opens.

2. Set the Administrative State to Up, and configure all other required parameters.

3. Click OK and confirm to close the form. A statistics configuration entry appears in the table.

Note: Statistics are not collected unless there are at least two NEs using the policy.

Click on the Static Policies tab. Create segment routing static policies by performing the following:

1. Click Create. The Segment Routing Static Policy form opens.

2. Configure the parameters in the General tab.

3. If you will need to use Seamless BFD, click Select in the Maintenance Policy panel to add a maintenance policy; see To configure a maintenance policy.

4. Click on the Segment List tab and click Create. The Segment List form opens.

5. Configure the parameters on the General tab.

6. Click on the Segment List Entries tab and click Create. The Segment List Entry form opens.

7. Configure the parameters then click OK and confirm to close the Segment List Entry form. A segment list entry appears in the table.

8. Click OK and confirm to close the Segment List form. A segment list appears in the table.

9. Click on the Segment Routing SRv6 tab, and then on the Binding SID sub-tab.

10. Click Create. The Binding SID form opens.

11. Configure the parameters on the General tab.

12. Click OK and confirm to close the Binding SID form.

13. Click OK and confirm to close the Segment Routing Static Policy form. A static policy appears in the table.

Click OK and confirm to close the Segment Routing Policy form.

End of steps