Static Routes report
Static Routes report overview
The Static Routes report shows the detailed information of the route traversed, destination, gateway and the interface type for the selected NEs.
Use cases
Use the report to examine the static route defined on a selected NE.
Report characteristics
The following table lists the principal report characteristics.
Table 15-7: Static Routes report characteristics
|
Characteristic |
Value | |||||
|---|---|---|---|---|---|---|
|
Source database |
NSP database | |||||
|
NE types supported |
Wavence MSS-4, Wavence MSS-8, Wavence MSS-E, Wavence MSS-HE, Wavence MSS-XE, Wavence UBT SA, 9500 MPR-E Chassis 4, 9500 MPR-E Chassis 8, 9500 MSS-O ETSI, 9500 SA Note: The 7705 SAR-H is not supported. | |||||
|
Report inputs |
Prompt |
Notes | ||||
|
Name or name pattern for NEs |
Enter the name pattern of the NE. | |||||
|
NEs |
A maximum of first 1000 entries from the available list of NEs are displayed. Select individual NEs or click Select All. | |||||
|
Logo Resource ID |
The logo to add to the report. Enter the Resource ID of the logo image in the Images folder. The default is the Nokia logo. To create the report without a logo, leave the Logo Resource ID field blank. | |||||
|
Logo Position |
Choose Left, Middle, or Right. The logo appears on the left on the first page of the report if you choose Left or Middle. | |||||
|
Show report output on one page |
Select the check box to enable pagination. Note: Using the Show report output on one page option when creating reports as drill-downs may impact report rendering time. Nokia recommends disabling the Show report output on one page option when creating reports. | |||||
|
Apply |
Applies all the parameters and prepares the report. | |||||
|
Reset |
Resets all the parameters to default value. | |||||
|
Drill-down support |
No | |||||
Example
The following figures show a report example.
Figure 15-8: Static Routes report
