To verify the FIB configuration

Purpose

This procedure describes how to verify the connectivity of customer equipment on the service tunnel.

Steps
 

Click on the L2 Access Interfaces tab on the Services (Edit) form. A list of L2 access interfaces appears.


Double-click on a row in the list. The L2 Access Interface form appears.


Click on the Forwarding Control tab.


Click on the FIB Entries tab.


Click Resync.

  1. If there is a list of FIB entries, confirm the number of entries with the customer configuration requirement. If the configuration meets the customer requirement, go to Stage 5 in Workflow to troubleshoot a service or connectivity problem.

  2. If there are no FIB entries, there is a configuration problem with the customer equipment or the connection from the equipment to the service tunnel.

    1. Confirm that the NFM-P service configuration aligns with the customer requirements.

    2. Confirm that there are no problems with the customer equipment and associated configuration.


If the service problem persists, another type of service problem may be present. Perform the steps of the Workflow to troubleshoot a service or connectivity problem troubleshooting workflow.


If the workflow does not identify the problem with your service, contact your technical support representative; see Chapter 1, NSP troubleshooting overview.

End of steps