Problem: NSP data synchronization is not 100%
Issue
If you run the procedure “How do I check NSP database synchronization?” in the NSP System Administrator Guide and do not get a 100% synchronized result, this indicates that a switchover occurred before the system had stabilized and nsp-tomcat on the standby site had caught up with the active site. The following workaround describes how to synchronize the data.
Steps
1 |
Perform a switchover to go back to the previous active site. |
2 |
Wait for database instances to sync up. |
3 |
Perform another switchover. |
4 |
Run the procedure “How do I check NSP database synchronization?” again to verify the active and standby databases are 100% synchronized. End of steps |