LAG parameters

Auto-Generate

The Auto Generate parameter specifies whether to automatically configure an Actor Administration Key parameter.

The options are:

  • Enabled (default)

  • Disabled

Hash

The Hash for Ethernet LAG enabled parameter specifies service-level hashing for Ethernet services on the Wavence SM.

The options are:

  • L1

  • L2

  • L3

Show Only Compatible Ports

The Show Only Compatible Port Numbers parameter specifies whether to filter the list of ports presented, by determining whether the ports can be configured as LAGs.

The options are:

  • Enabled (default)

  • Disabled

When the parameter is enabled, several checks are performed.

Which of the following checks are performed depends on the type of NE:

  • the port mode is network

  • the port cannot be a mobile port

  • the port cannot be POS

  • the port cannot belong to another LAG

  • there cannot be more than eight ports in a LAG

  • the port cannot be bound to a Layer 3 interface

  • the ports must have the same speed

  • the port must be set to full duplex and auto negotiation must be turned off

View the newly created Port Termination

The View the newly created Port Termination parameter specifies that the Properties form for the newly created LAG opens when you close the configuration form.

Wait to Restore (ms)

The Wait to Restore (ms) parameter specifies the amount of time to wait after a fault clears before a traffic interface is restarted in the LAG. This parameter is specific to Wavence NEs. The range is 100 to 8000. The default is 1000.