To create a Dynamic or segment routing LSP from a tunnel template

Purpose

Before you can create an LSP from a tunnel template, you must create the tunnel template. You can use an existing LSP to create a tunnel template.

Steps
 
1 

Choose Manage→MPLS→(Dynamic|Segment Routing) LSPs from the NFM-P main menu. The Manage (Dynamic|Segment Routing) LSPs form opens.

2 

Click Create from Template. A Create (Dynamic|Segment Routing) LSP from Template form opens with a list of tunnel templates.

3 

Choose a template and click OK. A Create (Dynamic|Segment Routing) LSP from Template form opens.

4 

Configure the required parameters.

5 

Specify the source sites for the LSP.

  1. Select a Source Site ID and click OK.

  2. Select a Source IP Address and click OK.

6 

Configure the Destination Site ID and the Destination IP Address parameters.

7 

Click on the Accounting tab and select an accounting policy.

8 

Click OK.

9 

Configure the Collect Accounting Statistics and the Administrative State parameters.

10 

Click on the Properties tab and configure the required parameters.

Note: The number of parameters that can be configured depends on how the template was created. All of the parameters are configurable when the template is based on an object. A subset of the parameters can be configured when the template is based on an object class.

11 

Click OK. The Create (Dynamic|Segment Routing) LSP from Template form closes.

12 

When the Show Created Object parameter is enabled on the template, the (Dynamic|Segment Routing) LSP (Edit) form opens. Close the (Dynamic|Segment Routing) LSP (Edit) form.

13 

Close the Manage (Dynamic|Segment Routing) LSPs form.

End of steps