To configure a multicast redirect interface on a local routing policy statement
General Information
To perform this procedure, you must use a global routing policy statement that has been released and distributed to one or more NEs. See To configure a routing policy statement for more information.
Steps
1 |
Choose Policies→Routing→Statement from the NFM-P main menu. The Routing Policy - Statements form opens. |
2 |
Choose a policy and click Properties. The Routing Policy - Statement form opens. |
3 |
Click on the Local Definitions tab. The sites the Routing policy statement is distributed to are listed. |
4 |
Choose a site and click Properties. The Routing Policy - Statement, Site Local Policy form opens. |
5 |
Click on the Policy Statement Entries tab. |
6 |
Choose a policy statement and click Properties. The Policy Statement Entry, Routing Policy, Site form opens. |
7 |
Click on the Action tab. The Action tab is only available if the Action parameter on the Policy Statement was set to Accept, Next Entry, or Next Policy. |
8 |
Click Select to choose an interface in the Multicast Redirection panel. The Select Interface - Policy Statement Action - Site form opens. |
9 |
Select an interface and save your changes. The Policy Statement Entry, Routing Policy, Site form reappears. |
10 |
Save your changes and close the form. The Policy Statement Entry, Routing Policy, Site form reappears. See To release and distribute a policy to release and distribute the policy to NEs. End of steps |