To configure a Shared Risk Link Group policy

General Information

See Shared Risk Link Group policies in this chapter for more information.

Steps
 
1 

Choose Policies→Routing→Shared Risk Link Group from the NFM-P main menu. The Routing Policy - Shared Risk Link Group Policy form opens.

2 

Click Create or choose a policy and click Properties. The Shared Risk Link Group, Global Policy (Create|Edit) form opens.

3 

Configure the required parameters on the General tab.

4 

Click Apply to save the policy. The form refreshes with additional tabs.

5 

Configure the parameters or view the information associated with each tab as required. Table 54-7, Description of Shared Risk Link Group Policy form tabs describes the tabs you can configure/view.

6 

Configure the parameters or view the information associated with each tab as required. Table 54-7, Description of Shared Risk Link Group Policy form tabs describes the tabs you can configure/view.

Table 54-7: Description of Shared Risk Link Group Policy form tabs

Tab

Description

Local Definitions

Lists Shared Risk Link Group policies and allows you to manage policy distribution.

Interfaces

Lists and allows you to manage MPLS interfaces to which the SRLG policy has been assigned. You can access the following interface types on the sub-tabs:

  • MPLS

  • L3 access

  • network

  • tunnel

Faults

List and manage alarms related to the SRLG.

7 

Save your changes and close the form. See To release and distribute a policy to release and distribute the policy to NEs.

Note: A routing policy is discovered as local edit only. To synchronize a routing policy with all NEs, you must change the distribution mode of the routing policy to sync with the global policy. See To change the distribution mode of a policy to change the distribution mode of a routing policy.

End of steps