Routing protocol configuration pathway

Stages
 
1 

Configure a base routing instance or VRF instance on a device; see To configure a routing instance or a VRF instance .

2 

Enable the routing protocols to be supported on the device or routing instance. The supported protocols are device dependent. The options are:

Note: L2TP is enabled by default on a base routing instance, but not on a VPRN routing instance.

3 

Configure L3 network interfaces as required if you need to enable multicast routing protocols. See the Pathway: Configure NE routing and forwarding in Chapter 27, NE routing and forwarding .

4 

Configure the appropriate routing policies as required; see Chapter 54, Routing policies .

5 

Review the following protocol pathways as required to configure additional functionality:

  1. BGP and MP-BGP; see Pathway: Configure BGP and MP-BGP

  2. RIP; see RIP and RIPng configuration pathway

  3. LDP; see Pathway: Configure LDP

  4. IS-IS; see Pathway: Configure IS-IS

  5. OSPFv2 or OSPFv3; see Pathway: Configure OSPFv2 and OSPFv3

  6. RSVP; see Pathway: Configure RSVP

  7. L2TP; see Pathway: Configure L2TP

  8. PIM; see Pathway: Configure PIM

  9. IGMP; see Pathway: Configure IGMP

  10. MSDP; see Pathway: Configure MSDP

  11. MLD; see Pathway: Configure MLD

  12. bridging; see Pathway: Configure bridging on an OmniSwitch

  13. WPP; see Pathway: Configure WPP

  14. BIER; see Pathway: Configure BIER

  15. IPSec; see Pathway: Configure IPSec

6 

Configure routing protocol monitoring as required; see Pathway: Configure BMP.

7 

Configure the protocol for the remote device as required.