Perform Step 1 of To create an ILMI link to open the ATM Configuration (Edit) form.

Click Edit ILMI Link. The ILMI Link form opens.

Configure the required parameters.

The Restore Keep-Alive Defaults parameter restores the default values of the Keep-Alive Polling Frequency (seconds), Keep-Alive Polling Count, and Keep-Alive Test Frequency (seconds) parameters.

The Keep-Alive Test Frequency (seconds) parameter is configurable when the Protocol Version parameter is set to 4.0.

Choose an ingress ATM QoS policy by clicking Select. The Select ATM Policy - ATM ILMI Link Configuration list form opens. Click Search and choose an ingress ATM policy from the list to associate with the ILMI link. Click OK. The Select ATM Policy - ATM ILMI Link Configuration list form closes.

Choose an egress ATM QoS policy by clicking Select. The Select ATM Policy - ATM ILMI Link Configuration list form opens. Click Search and choose an egress ATM policy from the list to associate with the ILMI link. Click OK. The Select ATM Policy - ATM ILMI Link Configuration list form closes.

Click on the Peer Interface Configuration tab to view ILMI properties of the peer interface of the link.

Click OK to close the Configure ILMI Link form. The ATM Configuration (Edit) form opens.

To remove an ILMI link, click Remove ILMI Link. Removing the ILMI link also removes the PVC.

Note: An ILMI link can be removed only if its Administrative Status parameter is set to Disabled.

Click Cancel to close the forms.

End of steps