To create a mirror service
Before you begin
If you are configuring mirror services using dot1q or QinQ SAPs on a 7210 SAS (except for a 7210 SAS-D or 7210 SAS-K), then you must first assign a no-service mirror port. See To configure a mirror port on a 7210 SAS .
Steps
1 |
Choose Create→Service→Mirror from the NFM-P main menu. The Mirror Service (Create) form opens. |
2 |
Configure the required general parameters. The Service ID and SVC Mgr Service ID parameters are configurable when the Auto-Assign ID parameter is disabled. |
3 |
If you enabled the Automatic SDP Binding Creation parameter, select a tunnel selection profile in the Auto SDP Binding Creation panel. |
4 |
To configure a mirror source on a destination site, perform To create a destination site on a mirror service . |
5 |
To configure a mirror source on a site other than the destination site, perform Step 3 to Step 12 of To create a source site on a mirror service . Otherwise, go to Step 6 . |
6 |
Save the changes and close the forms. End of steps |