To resolve Wavence MIB inconsistencies
Purpose
Perform this procedure to resolve NE inconsistencies created due to MIB population failures that can occur during service creation on a Wavence NE. If there are NE inconsistencies, the Cleanup Inconsistencies button on the Wavence network element form becomes active to provide a visual cue that action is required to resolve them.
Nokia recommends that inconsistencies be resolved before any service creation. For failures during Wavence service creation, perform a resynchronization of the NE to restore existing NE entries. Inconsistencies are detected during NE synchronization or when opening the NE Properties form. If there are inconsistencies, an alarm with a Warning severity level on the NE appears.
Steps
1 |
In the navigation tree Equipment view, right-click on a Wavence and choose Properties. The Wavence network element form opens. |
2 |
Click Cleanup Inconsistencies. NFM-P attempts to resolve the NE MIB inconsistencies. |
3 |
To verify all MIB NE inconsistencies are resolved, click on the Faults tab to check for any remaining inconsistency alarms. |
4 |
Click on the Abnormal Conditions tab to check for abnormal conditions on the Wavence, such as loopback or TxMute conditions, and to determine the appropriate corrective actions. Note: You must refresh the Abnormal Conditions tab to ensure the latest content is displayed. Note: You can clear the abnormal condition alarm after all the individual abnormal conditions are cleared. |
5 |
Close the form. End of steps |