Process to enable CN telemetry
Purpose
Use this procedure to set up CN telemetry on NSP. Some steps in this procedure are only required if third-party NEs are in use.
Deploy CN telemetry
1 |
Open a terminal session to the NSP deployer VM |
2 |
Log in as the root or NSP admin user. |
3 |
Enable the GNMI Telemetry and Accounting Telemetry installation options in the NSP deployment as needed; see How do I update the NSP system configuration?. |
Upgrade adaptors to 25.8 or later
Adaptors from releases earlier than 23.11 must be upgraded to use CN telemetry.
1 |
Obtain the new adaptor adaptation bundle from the Nokia NSP software delivery site, in the NSP/<release>/Artifacts folder. |
2 |
Install the new adaptor adaptation bundle, see “How do I install an artifact bundle?” in the NSP Network Automation Guide. Note: it is not necessary to remove the older adaptors when upgrading. |
3 |
See the artifact guides for your NEs for any additional required steps. |
Enable TLS
1 |
Transfer the TLS certificate file for each NE to the following directory on the NSP deployer VM: /opt/nsp/NSP-CN-DEP-release-ID/NSP-CN-release-ID/tls/telemetry See the NE documentation for information about generating NE TLS certificate files. |
2 |
Enter the following to apply the certificates: # /opt/nsp/NSP-CN-DEP-release-ID/bin/nspdeployerctl install --config –-deploy↵ Do not modify or delete files in this directory. |
Check the Telemetry Statistic Search Tool
CN telemetry is enabled for gNMI and accounting collection. You can verify the availability of the telemetry types you need in the Telemetry Statistic Search Tool.
1 |
Open the Telemetry Statistic Search Tool and search for your desired telemetry types. If you do not find the definition or mapping you require, or you need to augment an existing telemetry type, contact your Nokia service representative. |