To configure EVPN on an Epipe site

Steps
 
1 

Choose Manage→Service→Services from the NFM-P main menu. The Manage Services form opens.

2 

Select the required Epipe and click Properties. The Epipe Service (Edit) form opens.

3 

On the service tree, expand Sites and click on the site on which you want to configure a VXLAN.

4 

In the General tab, configure the Source IP Address parameter in the VXLAN Tunnel End Point panel.

5 

Click on the BGP tab, and then on the EVPN sub-tab.

6 

In the BGP EVPN panel, click Create, or choose a BGP EVPN and click Properties. The BGP EVPN - Epipe Create/Edit form opens.

Note: For 7750 SR, 7250 IXR, 7450 ESS, and 7950 XRS nodes only.

For NFM-P releases earlier than 26.4, and node releases earlier than 26.3, the SRv6 Instance ID and Default Locator parameters are available in the SRv6 BGP EVPN - Epipe Create/Edit form. For NFM-P 26.4 and later, and node releases 26.3 and later, the SRv6 Instance ID and Default Locator parameters are available in the Local Attachment Circuit - Epipe Create/Edit form.

For NFM-P 26.4 and later, and node releases 26.3 and later, when sending a request using OSSI, the BgpEvpnSRv6 object must not include the srv6Instance and defaultLocator parameters.

7 

Configure the required parameters.

8 

Configure the attachment circuits.

You can configure up to two local and two remote attachment circuits, on supporting NEs.

  1. In the Local Attachment Circuit panel, click Create, or choose an item in the list and click Properties. The Local Attachment Circuit - Epipe Create/Edit form opens.

  2. Configure the required parameters.

  3. Save your changes and close the form.

  4. In the Remote Attachment Circuit panel, click Create, or choose an item in the list and click Properties. The Remote Attachment Circuit - Epipe Create/Edit form opens.

  5. Configure the required parameters.

  6. Save your changes and close the form.

9 

Configure the parameters in the MPLS panel, as required.

10 

Configure the segment routing with IPv6.

  1. In the Segment Routing V6 panel, click Create, or choose an item in the list and click Properties. The SRv6 BGP EVPN - Epipe Service Create/Edit form opens.

  2. Configure the required parameters.

  3. Save your changes and close the form.

11 

Configure the parameters in the Auto Bind Tunnel panel, as required.

12 

Configure a network identifier for the VXLAN.

  1. Click Create in the VXLAN panel. The VXLAN (Create) form opens.

  2. Configure the network identifier.

  3. Configure the remaining parameters as required.

  4. Click OK and confirm to close the form.

13 

Save and close the form.

End of steps