The WaveStar® CIT is the primary tool used to interface with the Alcatel-Lucent 1665 DMX for managing synchronous interfaces and SONET operations. The WaveStar® CIT client software is installed on a personal computer (PC), and provides the Alcatel-Lucent 1665 DMX user-interface for SONET operations.
It is anticipated that most customers will dedicate a laptop or personal computer (PC) to run the WaveStar® CIT software. However, any properly configured computer will suffice.
The following table lists the customer-provided PC minimum and recommended requirements for using the WaveStar® CIT.
Component |
Minimum 1 |
Recommended |
---|---|---|
Processor |
Pentium II 266 MHz |
Pentium IV 1GHz or higher |
RAM (one System View) |
256 MB |
512 MB |
RAM (up to 5 System Views) |
512 MB |
1 GB |
Virtual memory |
139 MB |
267 MB |
Available disk space |
750 MB |
850 MB 2 |
Video |
800x600 256 colors (8 bit) |
1024x768 16 million colors (24 bit) |
Network Interface card |
10/100BASE-T Network Interface Card 10/100 BASE-T LAN interface Pin Designations/signals are: | |
CD-ROM drive |
Required | |
Operating System |
Supported Operating Systems are: The customer is responsible for ensuring that the PC remains virus-free. | |
Internet Browser |
Microsoft® Internet Explorer 5.0, 5.5, 6.0, or 7.0 |
Minimum requirements are sufficient to run two or three graphical System Views, unless otherwise noted. Recommended requirements are intended to be used as a general guideline to optimize WaveStar® CIT performance. Since the WaveStar® CIT is used with multiple NE connections and multiple NE types, the processor type and speed and the memory size all factor into the performance.
Available hard disk space required to install and store the WaveStar® CIT and on-line help files is approximately 750 MB. During installation, an additional 100 MB is required. To store a copy of an NE generic, another 125 MB is needed for each generic
November 2011 | Copyright © 2011 Alcatel-Lucent. All rights reserved. |