Clear "CP not allowed

Procedure 5-10: Clear "CP not allowed - crs" alarm

Overview

This procedure is used to clear a CP not allowed - crs alarm.

Before you begin

Prior to performing this procedure:

Refer to Before you begin and Required equipment in this chapter.
Refer to Laser safety and Electrostatic discharge in Chapter 1, Safety.

Steps

Complete the following steps to clear a CP not allowed - crs alarm.

From the WaveStar^® CIT System View, click the Alarm List button and locate the CP not allowed - crs alarm in the resulting alarm list.

Determine the alarm level(s) for the active CP not allowed - crs alarm(s). Clear the alarms in order of severity.

Refer to the Probable Cause column in the alarm list, determine the affected circuit pack, and note the corresponding slot AID.

Select Reports → Equipment Lists → Pack. Click Shelf and Select to obtain the Circuit Pack List. Observe the correct circuit pack information for the required slot.

Compare the correct circuit pack information from the Circuit Pack List with the circuit pack that is physically in the required slot.

If the circuit packs...

Then...

are the same type,

Perform the following:

Select View → Cross-Connections. Select the required circuit pack and click Select to obtain a list of cross-connections. Observe the provisioned cross-connections for the required circuit pack and compare with office records.
Select Configuration → Cross-Connections to access the Cross-Connection Wizard and make the required cross-connections changes to/from the circuit pack.

are not the same type,

Perform the following:

Obtain the correct type of circuit pack (according to the Circuit Pack List) for the required slot.
Replace the wrong circuit pack currently in the required slot with the correct circuit pack. Refer to the appropriate circuit pack replacement procedure in Chapter 6, Supporting procedures.

End of steps